NOTICE: TO ALL CONCERNED Certain text files
and messages contained on this site deal
with activities and devices which would be
in violation of various Federal, State, and
local laws if actually carried out or constructed.
The webmasters of this site do not advocate
the breaking of any law. Our text files and
message bases are for informational purposes
only. We recommend that you contact your
local law enforcement officials before undertaking
any project based upon any information obtained
from this or any other web site. We do not
guarantee that any of the information contained
on this system is correct, workable, or factual.
We are not responsible for, nor do we assume
any liability for, damages resulting from
the use of any information on this site.
Guns are expensive. This is a way to make
a cheap one-shot
gun for self defense.
You
wonft be able to
get off more than
one shot,
as it takes time
to reload, but itfs
the
shot no one knows
you have. The materials
you need are as follows:
1. 1.5cm diameter
steel pipe length:20-30cm.
2. PVC pipe so that
the steel pipe fits
snugly
into it.
3. Cap for the steel
pipe.
4. Cap for the PVC
pipe.
5. Epoxy.
6. Tape
7. A few boxes of
matches.
8. Piece of wood.
9. Knife.
10. Drill.
You can get most
of this stuff at a DIY store
near you.
How to make the pipe
gun.
1. Take the steel
pipe, attach and epoxy
the cap to one end.
2. Take the plastic
pipe, attach and
epoxy
the cap to one end.
3. Insert the steel
pipe into the plastic
one, using epoxy
to bind them.
4. Bind both pipes
around with tape (the
plastic pipe and
the tape are a safety measure,
you donft have use
them, unless you value
the use of your hands).
5. Wait for the epoxy
6. Drill a 5mm hole
2.5cm from the capped
end, through the
tape and both pipes.
7. Cut the striking
part off a matchbox and
glue or tape it next
to the hole.
8. The barrel is
basically finished.
You
can use it just like
this for extra concealment
and skip the steps
9 and 10. 9. Cut
the piece
of wood into the
shape of a handle,
with
a grove on the top
to fit the barrel.
10. Epoxy the barrel
to the handle. You
could
also use metal brackets
but this way is securer.
To load your new
pipe gun: Cut a matchbox
or two worth of match
heads, make sure
the
wooden part of the
match is totally
removed.
Crumble the match
heads up some, wrap
them
in a piece of tissue
paper or some such
thin
paper and stuff it
down the tube with
a rod.
Alternately you can
use gunpowder, if
you
can get it. Now,
take several nails,
ball
bearings, fishing
weights or something
like
that and push them
down the barrel on
top
of the tissue and
match heads. To fire
the
gun, take a match,
strike against the
striking
pad you glued to
the barrel and insert
it
into the hole: BANG.
This weapon is rather
limited because it
canft hit anything
at
a distance of more
than about 3m. Best
is
pointing it directly
at your attackerfs
eye from a distance
of 10 cm. I donft
take
any responsibility
if you use this weapon
to injure yourself
or anyone else.
|
